Mixes to Matrix

Forums › Forums › Qu Forums › Qu general discussions › Mixes to Matrix

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of HangDawg HangDawg 9 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2014/09/11 at 2:48 pm #41550
    Profile photo of HangDawg
    HangDawg
    Participant

    When a mix is sent to a matrix, does it retain the compression settings that are applied to the mix?

    2014/09/11 at 5:48 pm #41553
    Profile photo of HangDawg
    HangDawg
    Participant

    Found a good block diagram. By the looks of it, L+R/Mixes/Groups all send to the matrix post processing. That is truly great as it appears that I could use a stereo matrix out instead of L+R for mains. Doing so, it would be possible to simulate 6 stereo groups instead of just 2. I like to have sub mixes to apply compression on say, all the drums or all the vocals.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.