Mix Bus with DAW

Forums › Forums › Qu Forums › Qu troubleshooting › Mix Bus with DAW

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 2015/03/31 at 5:27 pm #46455
    Profile photo of NemixNemix
    Participant

    I am trying to create multiple mix sends to go from QU 24 to a headphone Amp while using the desk as a DAW controller/interface in a studio environment but can’t seem to find a way to route through to the mix faders.

    Does anyone have a workaround or solution to this please?

    2015/03/31 at 6:10 pm #46456
    Profile photo of NemixNemix
    Participant

    I have sorted it.

    2015/03/31 at 9:08 pm #46466
    Profile photo of SteffenRSteffenR
    Participant

    RTFM, simple

    2015/03/31 at 10:09 pm #46469
    Profile photo of NemixNemix
    Participant

    Its not simple actually and its not in the user guide. The section on output patch set up is very vague and basic. As it turns out, using the patch bay you can only route to stereo channel faders 2 and 3 to use as control for 2 stereo mixes unless you sacrifice some of the 24 input channels. Its always better to be helpful on these forums.

    2015/05/13 at 3:39 am #47955
    Profile photo of BodieBodie
    Participant

    I’m a brand newbie to Allen & Heath, and have had the same problem. Would you mind telling me how you routed your headphone mix?

    2015/05/13 at 6:16 am #47958
    Profile photo of Anonymous
    Inactive

    Or even which section of the manual was relevant…

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.