ME-1 Driving stage monitors / wedges.

Forums › Forums › ME Forums › ME general discussions › ME-1 Driving stage monitors / wedges.

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of  Anonymous 7 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2016/04/22 at 10:11 pm #55249
    Profile photo of
    Anonymous

    Anyone actually doing this?
    I did read a post, must have been over a year ago about a band touring, using 4 ME-1s’ to drive monitors / wedges. I lost the post & could not find it again.

    This has come to mind after reading the article about Jeff Bridges and the Abiders.

    I did a little experimenting with this before a large concert a year ago, but wasn’t game to try.

    All postive discussion / feedback [pun] accepted.

    regards
    NZdave

    2016/04/27 at 5:04 pm #55315
    Profile photo of Silvermake
    Silvermake
    Participant

    I was doing it few times with drummers monitor/wedge. But I did it little bit more complicated way, because I route ME-1s output back to FOH console, so that I can do equalisation and have so called “master control” in that monitor feed. It was actually working very nice. 🙂

    2016/04/27 at 8:46 pm #55317
    Profile photo of
    Anonymous

    I route ME-1s output back to FOH console

    Thanks for repyling.
    I’mm a little confuded there?
    Did you then send that feed back (from FOH) to the drummers wedge via what means?
    Anaolgue or on a mix output?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.