Lost DCA strips

Forums › Forums › GLD Forums › GLD general discussions › Lost DCA strips

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of  Anonymous 4 years, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/12/20 at 11:08 pm #88358
    Profile photo of
    Anonymous

    I’m looking at a show file on a GLD112 and several of the strips have DCA some with red dots beside them. Looking at all the DC instructions I can find they all refer to manipulating the RED DCA fader strips. Ie.g. “press [Sel] on a DCA strip and open processing etc.” But I don’t have any DCA strips on faders. Anywhere! How can I access DCA control and/or how can I get those red DCA strips back please?

    2019/12/21 at 1:06 pm #88369
    Profile photo of Scott
    Scott
    Participant

    Press the “setup” button. Select the “control” tab. Select “Strip Assign”, then select the “DCA” vertical tab (on the left). Drag the needed DCAs onto the desired fader banks.

    2019/12/21 at 1:50 pm #88370
    Profile photo of
    Anonymous

    Ouch. Too easy! Thanks Scott

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.