Listen Bus Fader assignable to Channel Strip

Forums Forums SQ Forums SQ feature suggestions Listen Bus Fader assignable to Channel Strip

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of lightingman117 lightingman117 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #109300
    Profile photo of Zach B.
    Zach B.
    Participant

    It would be nice to have the listen bus fader be assignable to a channel strip. I am using an SQ5 (so no soft rotaries to assign) and I have a pair of monitors for the operator to listen to. I have had to use a Matrix for the monitor that combines the main output and an aux mix that I can use to listen to a single channel or group of channels. It would be really useful instead to have the listen bus be assignable to a fader strip.
    Thanks,
    Zach

    #109317
    Profile photo of lightingman117
    lightingman117
    Participant

    +1

    #109333
    Profile photo of Tom
    Tom
    Participant

    Sorry if I misunderstood, but couldn’t you just change the mixer role to “Listen Level”?
    Instead of a channel strip the listen level is on the main fader, but at least it’s on a fader.
    If you still need LR on a fader you can assign it to a channel strip.

    Reference Guide V1.5.0 Issue 5 12.13 Mixer Role and Master Fader Mode

    #109337
    Profile photo of lightingman117
    lightingman117
    Participant

    Yes, that is a perfectly fine way to work around. But the master fader is a bit different and is dynamic based on the selected mix.

    Best to leave it in mix master mode and assign listen level to a strip.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.