Channel Level Multitrack recording

Forums › Forums › Qu Forums › Qu general discussions › Channel Level Multitrack recording

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2016/10/21 at 11:31 am #58779
    Profile photo of OzOz
    Participant

    I’m not sure if the following assumption is correct.
    USB Multitrack recording ch1-16 uses the send send signals as source (raw post preamp, no processing, eq, aso).
    When I set the gain of the channel to 0db in the usb multitrack playback, should the reproduced signal have the same level as the recorded signal?
    Greetings from Germany
    Micha

    2016/10/21 at 2:08 pm #58792
    Profile photo of Anonymous
    Inactive

    So – recording post pre-amp, then playing back from the USB. The levels should be identical – though trim/polarity are also relevant I think.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.