LED Display in Fader Flip Mode

Forums › Forums › Qu Forums › Qu general discussions › LED Display in Fader Flip Mode

Tagged: , ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2014/06/02 at 4:42 pm #40022
    Profile photo of mamericamamerica
    Participant

    I was at my friend’s house on Thursday. He was playing some music through his Qu-16 ST-3. When he went into Fader-Flip Mode (for the main output), the LED’s corresponding to the frequencies started flashing.

    The next day I was setting up to use my board to use my Qu-16 as a monitor mixer. When I used Fader-Flip Mode (on Aux-1) to set the wedges, I didn’t get any LED action. We are both using Firmware 1.4

    Is that feature only available when the main output is selected?

    2014/06/02 at 7:35 pm #40027
    Profile photo of mervakamervaka
    Participant

    It needs to also be PAFLed. It’s the same RTA information as from the RTA screen.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.