ip8 with an SQ

Forums Forums SQ Forums SQ general discussions ip8 with an SQ

This topic contains 6 replies, has 6 voices, and was last updated by Profile photo of xyz xyz 3 months, 1 week ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #83841
    Profile photo of tfling
    tfling
    Participant

    Is it possible to control channels of an SQ from an AH IP8 controller?

    #83844
    Profile photo of xyz
    xyz
    Participant

    I would like to know that answer as well.

    #83849
    Profile photo of Showtime
    Showtime
    Participant

    The answer is no.

    Setup up of the ip1 ip6 ip8 has to be done from the console.

    This isn’t implementent in the sq serie’s

    Richard

    #83852
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    SQ and dLive (and Qu) use different control protocols, and whilst there are similarities, it would a complete rework of the IP8 firmware along with large additions to SQ firmware.
    We will continue to monitor demand for it’s use with SQ, but for now, the IP8 is only supported on a dLive system.

    Thanks,
    Keith.

    #83853
    Profile photo of Mfk0815
    Mfk0815
    Participant

    I have both, a dLive as well as a SQ. I also have a IP8 and would love to use it also on the SQ.

    #84564
    Profile photo of andka771
    andka771
    Participant

    If the IP8 can be used as an extra fader bank for the SQ mixers, they will immediately go from completely out of question to very interesting.
    Having just one fader bank is the only issue stopping me from buying one, as one fader bank doesn’t fit my workflow.

    I really hope that you will take the time needed to add the support for IP8 in SQ.

    Best regards,
    Andreas

    #84565
    Profile photo of xyz
    xyz
    Participant

    For marketing:
    Please make the iP8 available on ALL systems and
    you will get a loyalty base like never imagined!

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.