IP6 – Route channels to Stereo Matrix?

Forums › Forums › dLive Forums › dLive General Discussions › IP6 – Route channels to Stereo Matrix?

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2019/11/14 at 5:48 pm #87651
    Profile photo of markwyse24markwyse24
    Participant

    Hello,

    I am trying to setup a stereo matrix as a IEM feed and use a IP6 to control it. I am finding that I cannot program the IP6 with channels that control the send to that particular matrix. Channels assigned to the IP6 only control the send to the MAINS. This is odd as I am able to control channel sends to the matrix on the Surface no prob (as of firmware 1.70 when the feature was added)

    The reason I am trying to use a matrix instead of an aux is that I want to have the ability to send aux mixes to this matrix as well.

    Anybody else run into this?

    Thanks,
    Mark

  • Author
    Posts
Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.