Insert Point question

Forums Forums SQ Forums SQ general discussions Insert Point question

This topic contains 3 replies, has 2 voices, and was last updated by Profile photo of KeithJ A&H KeithJ A&H 3 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #107263
    Profile photo of blue439
    blue439
    Participant

    Is it possible to set the insert point on channels/busses? If so, how do you do it?

    #107276
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    @blue439

    The insert points in the channels are fixed in core architecture, so it’s not possible to move them around.
    If you’re wanting to use inserts later in the signal path, a workaround is to use either direct outputs or groups.

    Thanks,
    Keith.

    #107429
    Profile photo of blue439
    blue439
    Participant

    The insert point is directly after the gain and pre everything else?

    #107458
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    @blue439

    The SQ input channel insert point is post-gate, pre-EQ.
    The mix/output channel insert point is pre-GEQ.

    You can see both of these here – https://www.allen-heath.com/media/SQ_ReferenceGuide_V1_5_0.pdf#page=109&zoom=auto,-295,1

    Thanks,
    Keith.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.