In/Out on single EQ Bands?

Forums Forums dLive Forums dLive feature suggestions In/Out on single EQ Bands?

This topic contains 6 replies, has 4 voices, and was last updated by Profile photo of Albin Albin 6 years, 9 months ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #63748
    Profile photo of Albin
    Albin
    Participant

    Hi is it just me or is there no way to switch singe EQ Bands in and out?
    Not the whole EQ – but just single EQ bands.
    Would be great if this would be available.

    #63759
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Have you seen this on any other console?

    ddff

    #63760
    Profile photo of Albin
    Albin
    Participant

    Of course. The Avid Consoles for example.

    #63990
    Profile photo of Mr-B
    Mr-B
    Participant

    Would they default on or off? bit of a pain if you had to go around potentially turning 90 X 4 EQ bands on whilst trying to do everything else don’t you think?
    I guess I could see a potential use whilst trying to decide if the applied EQ was as required in a particular band, just seems an added layer of granularity I can easily live without.

    #63996
    Profile photo of Albin
    Albin
    Participant

    Of course all should be on by default.
    This should only be an option. I found it very usefull to have.

    #64008
    Profile photo of
    Anonymous

    I found it very usefull to have.

    For what exactly?

    #64009
    Profile photo of Albin
    Albin
    Participant

    For example: i have Bass guitar and on one song i need an boost on 2-3khz that is not needed on other Songs.
    So i just can hit “in” on that part and “out” if its over. Of course i can change the parameter itself but in and out would be easier…

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.