Independent gain/trim adjustment for stereo channel

Forums Forums SQ Forums SQ troubleshooting Independent gain/trim adjustment for stereo channel

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Dave Meadowcroft Dave Meadowcroft 4 years, 6 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #86279
    Profile photo of Rich
    Rich
    Participant

    Is this possible? Just noticed one of my synths is a bit hotter from the right than left channel (after many different cables/di boxes. Can set the gain on the inputs to compensate with two mono channels, but as soon as I pair them, they share a setting.

    I saw another thread that dealt with a variance in pad settings but that’s not the issue, it’s definitely the source that just needs slightly adjusted trims.

    #86283
    Profile photo of boota
    boota
    Participant

    I’d use input ganging instead of running it as a stereo channel

    #86286
    Profile photo of Dave Meadowcroft
    Dave Meadowcroft
    Participant

    I like the Yamaha way of doing this (it is on the LS9 at least – not sure if the same on their newer consoles) where faders and gains can be set seperately when unlinked and then maintain that offset once linked. Very helpful sometimes, more so for the gains than the faders though.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.