How to set LR & mono outputs separate?

Forums › Forums › Qu Forums › Qu troubleshooting › How to set LR & mono outputs separate?

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Giga Giga 2 years, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2021/10/16 at 12:27 pm #104035
    Profile photo of Razakey
    Razakey
    Participant

    I bought new QU16 desk last week, and I found out that it’s a little bit different with X32 consoles. My question is, how to set separate LR and Mono outputs. Let’s say, if I want to send Low frequency instrument to Sub/mono channel, can someone explain how to do that? Thanks in advance.

    2021/10/16 at 4:31 pm #104040
    Profile photo of Giga
    Giga
    Participant

    The Qu series doesn’t have that option out of the box. You could try to emulate it using a mono monitor out and use the high- and lowpass filters in that mono output and mains as a pseudo crossover.

    Good luck !

    Giga

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.