How to replace group with Mix Send

Forums Forums SQ Forums SQ general discussions How to replace group with Mix Send

Tagged: 

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Simon2 Simon2 2 weeks, 1 day ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #122506
    Profile photo of DJSHANIL
    DJSHANIL
    Participant

    Hi! I have just purchased an SQ5 console. I have seen people running the 9-12 mix sends however when I click on these it just goes to a group out.

    Can anyone help me out with changing from group to another mix send?

    I usually do large bands so would ideally want to give every musician a seperate mix send rather than get anybody to share.

    Can someone please help? TIA!

    #122508
    Profile photo of SQuser
    SQuser
    Participant

    If you have still no experience with this console, please look in the manual first – e.g. page 71.

    Attachments:
    You must be logged in to view attached files.
    #122528
    Profile photo of Brian
    Brian
    Participant

    please look in the manual first – e.g. page 71.

    Totally off subject, but who designs these interfaces??? If the Auxes are always going to be “numbered” first in the console, then it would make sense to have the auxes listed on the left side of that setup screen (because they are going to be “first”). Instead A&H has decided to place “groups” first in the GUI even when they are “numbered” second (after the auxes) in the system. I suspect this causes a lot of confusion with users until they use to this “quirk.” I’m guessing they left the GUI design up to some technical engineers instead of someone with some more graphical design experience.

    #122539
    Profile photo of Simon2
    Simon2
    Participant

    …I suspect this causes a lot of confusion with users until they use to this “quirk.”..

    Yep. Here is one (resp. three, as we work in a team). 😅

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.