Gld Dante to SQ dante ( and viceversa)

[Tom]

Hi,
i connect my gld 112 with dante card ( firmware 4.0.3.8) to my sq6 dante (firmware 1.0.5).

I have always digital clipping. I try 3 cable cat 6 but the result is the same. I try all latency setting in dante controller but nothing. The signal is present but sometimes i hear “tik tik” during sound and sometimes during silence.

This problem are the same in sq to gld direction.

Does anyone have any suggestions for resolution

Thanks all,
Thomas

[Jonathan]

It sounds like a clocking issue. You need to set both the GLD and SQ clocks to reference the Dante cards, not the internal clocks. On the GLD it is Setup > Audio > Audio Sync > Audio Clock Source. Change to Slave Option Card.

Hope that helps!

Jonathan

[Tom]

Just do it… Thanks for the reply, it is my carelessness!!!

[Author]

Posts