GLD and DT168

Forums Forums GLD Forums GLD general discussions GLD and DT168

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of Showtime Showtime 4 years, 6 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #86606
    Profile photo of Branimir
    Branimir
    Participant

    Is DT168 compatible with the m-Dante for GLD?

    Will there be future updates for GLD software to be able to control the preamp, phantom power on DT168?

    #86607
    Profile photo of Scott
    Scott
    Participant

    It looks like it should work according to the documents. It can run at either 48Khz or 96Khz depending on the clock master’s settings. If the GLD is the master, then there should be no reason that you couldn’t route signal between the devices using Dante Controller. I’m not sure how you would control the preamps however.

    #86609
    Profile photo of Branimir
    Branimir
    Participant

    SQ and dLive are able to control the gain and phantom, so maybe it could be implemented into GLD too via some future update?

    #86626
    Profile photo of SteffenR
    SteffenR
    Participant

    since the GLD is out of production I will doubt that

    #86627
    Profile photo of Showtime
    Showtime
    Participant

    The dante card for the gld isn’t capable of remote gain, the gld isn’t ready for remote gain on the io card.

    I don’t think that this wil be an option.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.