GLD 112 no sound output

Forums › Forums › GLD Forums › GLD troubleshooting › GLD 112 no sound output

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/12/05 at 4:09 pm #88094
    Profile photo of Anonymous
    Inactive

    we are in process of switching out iLive 112 to GLD112. just setup gld 112. did reset to factory defaults. no sound output. we have signal coming in, no sound out. cat5 connected to dSnake. steady flashing light. amps are turned on.
    help

    2019/12/05 at 5:21 pm #88102
    Profile photo of JonathanJonathan
    Participant

    Are you getting audio out of the headphones when you enable PAFL on the Main bus? Also, try using the signal generator. Are you using the dSnake for the Mains output or the surface outputs?

    2019/12/08 at 1:45 pm #88143
    Profile photo of Chris93Chris93
    Participant

    If you’re getting signal out of the LR bus, make sure your output patch is sending the LR mix to the correct outputs.

    If no signal at the LR bus, check the input channels are assigned to the LR, and that they aren’t assigned to a DCA which is turned down or muted.

    Chris

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.