GLD Maintenance Release – V1.62

Forums Forums GLD Forums GLD general discussions GLD Maintenance Release – V1.62

This topic contains 5 replies, has 6 voices, and was last updated by Profile photo of Terry Terry 4 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #106074
    Profile photo of Jack_AH
    Jack_AH
    Moderator

    Hi there!

    We’ve released a new firmware update for GLD, this supports hardware changes made to newer IO boxes.

    You can read all about the changes here:

    Release Notes

    Download it here:

    Firmware / Editor Download

    Please don’t forget to follow the firmware update instructions when performing a firmware update.

    Firmware Update Instructions

    #106373
    Profile photo of unico mix.ts
    unico mix.ts
    Participant

    Is this firmware update just for new audio racks?
    Are users of existing audio racks the same with V1.61?
    Did the parts change in recent audio racks?
    If so, is there a difference in sound quality or stability between the old and new audio racks?

    I have two sets of GLD80 / AR2412 / AR84 / dante systems.
    I like the ease of use of this system.
    We hope that the firmware update will continue in the future.
    thank you.

    #109182
    Profile photo of expert
    expert
    Participant

    Tell us your requirements. Very quick, cordial and efficient service from Car Expert.
    Car service

    #109535
    Profile photo of ELIS
    ELIS
    Participant

    After installing the firmware the mixer shutdown procedure is broken. It restarts the mixer into “fail mode” and needs to be started again. After this step, it can be shut down as usual.
    It’s bug of what?

    #109732
    Profile photo of jim
    jim
    Participant

    Same on shut down with ours.

    #116509
    Profile photo of Terry
    Terry
    Participant

    My soundboard does the same thing. It restarts several times and it not able to communicate with the expander.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.