FX Routing

Forums Forums Qu Forums Qu general discussions FX Routing

Tagged: 

This topic contains 4 replies, has 3 voices, and was last updated by Profile photo of Studiodawg Studiodawg 6 years ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #47467
    Profile photo of JD
    JD
    Participant

    … tried every combination, to no avail.

    I’m looking to set the FX for a channel, and then have the FX fully “muted” through the mains when the fader is down. Something simple, I’m sure – but I’ve tried every combination, to no avail.

    #47469
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    Read the downloadable manuals.

    If you are doing a channel insert this should work as wanted, if you are doing a mix->return then the mix needs to be postfade, if you are doing channel -> return then it will depend on the takeoff point selected.

    #47551
    Profile photo of Studiodawg
    Studiodawg
    Participant

    At the bottom of the FX screen there is a little rectangle with the word “Insert” in it. I discovered by accident that you need to tap that “Insert” to turn the effect on in the selected channel.

    #47553
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    Yes, you do need to actually insert the FX engine 😉

    There are too many ways to describe them all each time the question is asked, but once we know what the desired outcome is we can recommend a method and describe it…

    #47557
    Profile photo of Studiodawg
    Studiodawg
    Participant

    Thanks…this forum seems a lot “smarter” than most (much appreciated).

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.