Fader Display Issue

Forums › Forums › Avantis Forums › Avantis troubleshooting › Fader Display Issue

This topic contains 1 reply, has 1 voice, and was last updated by Profile photo of Phill Phill 1 year, 3 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2023/01/20 at 5:01 pm #111013
    Profile photo of Phill
    Phill
    Participant

    ok so first time on this… and Ive found the following:

    Fader 1 will goto +10db
    Fader 2-12 only goto +4db once I reach 4db the display stops counting…
    however if I push the fader to its left of infinity the display jumps to +10db…
    Just done a fader calibration and no difference an the desk is just out of the box..

    And as a point of note its not display orientated because Ive also just checked it with signal and the output from fader 2 jumps when I lift fader 1 of infinity…
    useless start :/

    Video attached…

    2023/01/20 at 5:33 pm #111015
    Profile photo of Phill
    Phill
    Participant

    I would upload the file but not with a 1meg limit… :/

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.