Dyn8 ganging bug?

Forums › Forums › dLive Forums › dLive troubleshooting › Dyn8 ganging bug?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2024/11/18 at 1:20 pm #127346
    Profile photo of pcbuilderpcbuilder
    Participant

    The ability to gang Dyn8, implemented in the latest firmware, is a VERY welcome addition. However, when a dynamic EQ band on one ganged channel is set to use an external key source, the corresponding EQ band in the ganged Dyn8 insert does not also change to the external key source but stays as self-keyed. Could this an intentional programming decision on A&H’s part, or a bug? Anyone else experiencing this?

    2024/11/25 at 11:34 pm #127548
    Profile photo of SteffenRSteffenR
    Participant

    I would think of an intentional behavior.
    Remember, a gang could include more than two channels.

    And the other dynamics in the channel don’t use the same key source too, if ganged.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.