DMO (DX1) > DX168 (no.1) > DX168 (no.2)
DMO (DX3+4) > DX168 (no.3)
Hi, having nightmare with initial power on for a 2 DX168 (1 and 2) being recognised by my DM0 (not every power on). Never have an issue with no.3 (even when swapped to DX3+4), this started to happen a few months ago at v1.83 (system is over a year old), upgraded to v1.85 and still having issues. DX168(3) is on 2m cables and DX168(1,2) are on 15m cables. After numerous reboots of DX168 (1,2), few reboots of the DM0, removing no.1 and going direct to no.2 (which forces firmware to be reloaded and reconfigurations) then going back to no.1…… it eventually comes good. Last night it took 1hr or faffing around. Once DM0 seems them there’s never any audio glitches and it all stays good until its power off and you have to start again…… any ideas….what a headache!
Thanks
.
