Different EQ behavior on SQ-Pad vs. Console

Forums Forums SQ Forums SQ general discussions Different EQ behavior on SQ-Pad vs. Console

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of [XAP]Bob [XAP]Bob 4 months, 1 week ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #68164
    Profile photo of Mfk0815
    Mfk0815
    Participant

    On the SQ-Pad app you can use the horzontal slider below the EQ graph to change the Q-factor of the EQ bands. for the LF and HF band it is possible, when you move the slider fully left, to change the filter type from Bell to Shelf. The console follows that changes. But on the console it is not possible to do that. Also on SQ-Pad only the slider can do that, not via the numeric parameter fields when you extend the EQ view.
    I would like to have also on the console the possibilty to switch from Bell to shelf and vice versa.

    BTW: Today I found out that for the QU-Series there is a spectrograph.

    #68186
    Profile photo of MarkPAman
    MarkPAman
    Participant

    Just a guess, but does it work like the QU?
    You can get a shelf by selecting the high or low q, then turning the screen encoder to the left. The dedicated encoders do not do that.

    #68189
    Profile photo of Mfk0815
    Mfk0815
    Participant

    You are right, thank you. Another hidden gem. Hmmm. nevertheless better that way as no shelf.

    #68199
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    The screen encoder also takes a couple of ‘spare’ clicks to get to the shelf – which is visible on screen.

    The dedicated knobs don’t allow that step transition because you can see when it would happen, and it is a major change of behaviour.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.