Dedicated reverb control for mix outputs?

Forums › Forums › Qu Forums › Qu general discussions › Dedicated reverb control for mix outputs?

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of dickiefunk dickiefunk 6 years, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2017/07/26 at 1:50 pm #64477
    Profile photo of dickiefunk
    dickiefunk
    Participant

    Hi,

    Is it possible to set up a monitoring reverb purely for the MIX outputs and be able to fully control the amount of reverb added to specific channels on each mix output?

    2017/07/28 at 10:40 am #64504
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    You can set up a monitoring reverb purely for sending to mixes.
    There is only one output from an FX unit though, so you can balance how much of each channel is sent to the reverb – but that is then locked into the output to whichever mixes it gets sent.

    If you need ‘more ch1 than ch2 in Mix1 and vice versa for Mix2’ then you’re SOL, or you need to burn two FX units.

    Digital mixers are awesome, and powerful, but they aren’t magic.

    2017/07/29 at 12:06 pm #64511
    Profile photo of dickiefunk
    dickiefunk
    Participant

    Ok. Thanks Bob.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.