DCAs for mixbus channel sends

Forums › Forums › SQ Forums › SQ feature suggestions › DCAs for mixbus channel sends

Tagged: ,

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of fishervillemedia fishervillemedia 3 years, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2020/05/15 at 1:33 pm #91862
    Profile photo of fishervillemedia
    fishervillemedia
    Participant

    I would like to have the option to configure a DCA to control channel sends to mixbuses. Currently DCAs affect channel sends to the master L/R mix only. An example would be that I have a set of channels routed to a separate mixbus for a live stream feed and I want a single DCA fader to control the volume of a certain number of those channels going to that live stream feed.

    2020/05/19 at 11:05 am #91963
    Profile photo of EJC
    EJC
    Participant

    I agree! This is one I requested a while ago (similar to MCAs on the higher line consoles)

    2020/05/19 at 11:31 am #91965
    Profile photo of fishervillemedia
    fishervillemedia
    Participant

    An even better solution for workflow would be “DCA follows mixbus”. That way, I can assign a DCA to a channel strip and as I cycle through the various mixbuses the DCA on that fader becomes active for the selected mixbus, just as all the other channel faders become active for the selected mixbus.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.