Connect ME-1 to SQ6, Avantis, DX168, DX Hub system

Forums › Forums › ME Forums › ME general discussions › Connect ME-1 to SQ6, Avantis, DX168, DX Hub system

Tagged: 

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of SteffenR SteffenR 3 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2021/04/16 at 3:49 pm #100724
    Profile photo of churchSound
    churchSound
    Participant

    I’m suggesting the below system to a House of Worship and want to make sure I can connect ME-1 to the system without using the ME-U.

    Mixers: Avantis (FOH), SQ6 (Broadcast)
    Snakes: 3 DX168 connected to Avantis
    Personal Monitor: 5 ME-1s
    Option Cards: Dante cards in both mixers

    Thoughts are to connect the ME-1 to a port on the DXHub. Will this work? Will I be able to see the channel names on the ME-1?

    2021/04/16 at 8:33 pm #100727
    Profile photo of Showtime
    Showtime
    Participant

    For if you want to work with the me system you better buy a gx4816 instead of 3x dx168

    The gx4816 has an sample rate port for the me system.

    Richard

    2021/04/17 at 8:10 am #100735
    Profile photo of SteffenR
    SteffenR
    Participant

    you can use a standard Fast Ethernet switch with POE to distribute the signal after the suggested GX4816

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.