Cable problem

Forums Forums Qu Forums Qu general discussions Cable problem

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of [XAP]Bob [XAP]Bob 7 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #57541
    Profile photo of Creator
    Creator
    Participant

    So I had to put a new end on one of my cat 5 cables, now when I connect to the snake and board I get a link error on the snake. Yes it’s wired right. Not sure what is causing this or how I should fix it. Should I cut it off and put a new end on both sides? While I get an error it still works but will randomly drop all audio.

    #57548
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    Remake that end, and do it right this time.

    Or get a proper network cable tester on. It will tell you where the break is, and in which cable…
    And how both ends are wired 😉

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.