Buzzing on left channel after plugging in the reccomended 1tb toshiba hard drive

Forums Forums Qu Forums Qu troubleshooting Buzzing on left channel after plugging in the reccomended 1tb toshiba hard drive

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Giga Giga 3 years, 5 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #66103
    Profile photo of hopcazz
    hopcazz
    Participant

    Hi guys just a quick one any reccomendations
    i have recently just purchased a reccomended a 1tb Toshiba hard drive and when i plug it in there’s a random buzz on the left channel and thenit stops but re appears when then drive reads or writes any ideas??

    Thanks
    carwyn

    #66104
    Profile photo of MarkPAman
    MarkPAman
    Participant

    Is St3 input turned up? Think that sometimes picks up noise when nothing’s plugged into it.

    #66110
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    St3 picks up noise specifically from the USB port unless it’s got a jack connected.

    Check routing via FX as well…

    #66121
    Profile photo of Giga
    Giga
    Participant

    Yeah, there definitely can be some crosstalk sometimes; until now I have always been able to get rid of it by pulling back all the faders that are not in use and/or unassign the channels in question.

    Good luck !

    Giga

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.