Bus Compression

[alpha]

Hey there,

I have a terrible noobish question and I can‘t figure it out. I‘m fairly new to the dlive experience and I come from the DAW mixer side(please don‘t judge to harsh). So I‘m used to bus compression and fx, especially drums and vocals. And I can‘t figure out how to realize a drum bus that comes a single fader on the desk into the main mix. Like 10 inputs into 1 stereo bus, then FX and compress that. I can‘t find a tut on it, or anything in the manuals.
So if someone could enlighten me it would be great and I would be eternally greatful.

Thanks

[Brent H.]

You’ll need to setup a stereo or mono group. Assign the channels you want in that group and assign the group to the Main LR.

[volounteer]

@alpha

I find the block diagram often clears up what the manual obfuscates.

Hopefully one of the experts will be along later if that does not give you enough info on how to route the signal from the group to where you want it to go to next.

Or is the real problem how to use only one fader?

[Author]

Posts