Avantis, Dx 168s and Dante 48k will it work.

Forums › Forums › Avantis Forums › Avantis General Discussions › Avantis, Dx 168s and Dante 48k will it work.

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of TheSoundDude TheSoundDude 4 years, 3 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/12/30 at 11:25 pm #88482
    Profile photo of Teddster
    Teddster
    Participant

    Hi folks, yes I’m being cheap and would rather not buy a new Dante card. Will this work or do I need a 96 ok Dante card? I’m planning to use the date card for multitrack to a daw.

    thoughts?

    Thanks!

    Tedd

    2019/12/31 at 1:35 pm #88499
    Profile photo of Scott
    Scott
    Participant

    If you’re asking can DX (96k) and a 48k Dante card coexist, the answer is yes since the DX connects to SLink which runs independently of the expansion card (Dante).

    What console is your current Dante card used in? If it’s an iLive, dLive, or GLD you can use it with this console. An adapter will be required for the iLive/GLD M-Dante card to fit.

    2019/12/31 at 3:16 pm #88501
    Profile photo of TheSoundDude
    TheSoundDude
    Participant

    Thank you Scott!
    Yes, I have the card in a GLD.

    I had read about the adapter, which is much cheaper than buying a new card. Understood, that my multitrack will be limited to 48k, but that is A-OK with me.

    Thanks again!

    Tedd

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.