Aux sends

Forums Forums SQ Forums SQ general discussions Aux sends

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of KeithJ A&H KeithJ A&H 4 years, 8 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #85510
    Profile photo of mkc
    mkc
    Participant

    Suspect the answer to this would be obvious with a console in front of me! Is it possible for some channels to send to a monitor mix post pre-amp (ie completely unaffected by any EQ or compression) and some post EQ. I see these options on page 35 of the user reference but they would appear to be global parameters that apply to all sends to the aux bus, is this correct?

    #85511
    Profile photo of MarkPAman
    MarkPAman
    Participant

    Pretty sure it’s only global.

    #85512
    Profile photo of KeithJ A&H
    KeithJ A&H
    Moderator

    Hi @msonix,

    The Direct Outputs are globally set, the Aux send tap-off point is set per mix (so not ‘global’ as each mix can be fed from a different point in the input channel).
    If you need to send from two different points in the input channels to a single monitor feed, you can use two Aux mixes (with different settings), then combine these using a Matrix to send out to the monitor.

    Cheers,
    Keith.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.