Audio doesnt pass whole channel strip

Forums › Forums › SQ Forums › SQ troubleshooting › Audio doesnt pass whole channel strip

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/06/12 at 9:02 pm #84561
    Profile photo of StearnStearn
    Participant

    Hi

    On one channel the audio is shown in the preamp section, but not in gate and further channelstrip.
    If I route the same source to another IP channel, it works normally. It doesn’t help to reset the desk or restart.

    Thanks for help

    2019/06/12 at 10:41 pm #84563
    Profile photo of Aivar JAivar J
    Participant

    If a channel does not send audio out from the faders, activate the insert and deactivate and it will work again.

    2019/06/14 at 4:33 pm #84601
    Profile photo of StearnStearn
    Participant

    Hi Aivar j

    Tanks for the tip, I’ll try it!

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.