Assign ST1 to CH32?

Forums › Forums › Qu Forums › Qu general discussions › Assign ST1 to CH32?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/08/11 at 3:09 pm #85786
    Profile photo of Chris J.Chris J.
    Participant

    I run a QU-32 for my church. I want to put all the inputs on to one layer for ease of use of our volunteers. I have everything there except I can’t figure out how to assign the ST1 input so it can be controlled with the CH32 strip on the bottom layer. Thanks for the help!

    2019/08/11 at 5:57 pm #85791
    Profile photo of volounteervolounteer
    Participant

    AFAIK you cant do that on the lower yellow layer.

    If you have a channel then you might be able to put it all on a middle custom layer that way.
    Otherwise you have to use the blue top layer to select ST1 to use mute or faders.

    2019/08/11 at 9:22 pm #85804
    Profile photo of BearBear
    Participant

    To change the custom layer Go to setup / control/ select the the channel you want to assign and change to ST1 .

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.