Alternant tie line config

Forums › Forums › dLive Forums › dLive feature suggestions › Alternant tie line config

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2023/01/08 at 7:46 pm #110792
    Profile photo of ToddTodd
    Participant

    Having the ability to do the same thing as the ABCD preamp selection but for tielines would be super helpful. A recent event I was on we had a backup RF channel setup. I was in monitors and was able to fail over to backup but FOH had to fail over on their own and I could not relay that quick enough. Being able to change the tie configuration from monitor world with a single button press would be amazing. I don’t want to have to do this with scenes as that is far too risky in my opinion.

    2023/01/29 at 5:44 pm #111188
    Profile photo of ParkerA1996ParkerA1996
    Participant

    Can you do this with a patchbay/IO library? I haven’t tried it yet with our supermadi card, otherwise you could patch your FOH to channel DO’s rather than directly from ports, then when you fire your ABCD change, theirs should follow.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.