Allen Heath zed 1000 noise

Forums Forums Other A&H products Allen Heath zed 1000 noise

This topic contains 5 replies, has 2 voices, and was last updated by Profile photo of Rob Rob 1 week, 5 days ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #104472
    Profile photo of Rob
    Rob
    Participant

    Hi I’m having problems Allen Heath zed 1000 so i had this unit so it’s been a nightmare with these mixers to be honest. My problem is once i bring the FX fader about 5 db you will start to hear kinda like a noise in speaker. I sent this mixer for repair the guy who worked on said in his shop hasn’t heard any noise what’s ever so I thought okay I hired electrician and i run wires straight from the breakers separate circuit all that fun stuff. The noise hasn’t gone away. Than i replace the FX board and that hasn’t solved anything.

    #104476
    Profile photo of Mike C
    Mike C
    Participant

    Does the noise change if you select different effects?

    Do you get the noise if all the yellow channel FX send knobs are
    turned down?

    #104478
    Profile photo of Rob
    Rob
    Participant

    when i select different effects the noise changes. It’s just annoying because i spend a lot of money and still hasn’t been able to trace this. not sure why is doing this crap is supposed to be quiet no noise what’s so ever

    #104479
    Profile photo of Rob
    Rob
    Participant

    No Noise if the FX channel is down once i raise it the fun begins

    #104480
    Profile photo of Mike C
    Mike C
    Participant

    I meant turning down the effect send knobs on each channel
    while leaving the yellow fader up.

    That would rule out any noise getting sent to the FX from
    a channel input.

    #104481
    Profile photo of Rob
    Rob
    Participant

    Sir please the noise is there evenn if there is no mic connected to the mixer channel, it should be no noise what’s so ever.

    Attachments:
    You must be logged in to view attached files.
Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.