AHM & Control Requests

Forums Forums Other A&H products AHM & Control Requests

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of JonM JonM 4 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #117497
    Profile photo of JonM
    JonM
    Participant

    For future AHM Custom Control Editor upgrades could I request the ability to select “Tab Position” also as Left or Right (Instead of just Top & Bottom), i.e. so that Tabs can align vertically to either side (This would allow TABS to emulate the Soft-Keys on the right hand side of an ip8)

    Also, can you advise if an iP6 or iP8 can be set to default to LAYER-1 on boot up? (rather than to it’s last used layer)

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.