Add FX Rack Units and Insert Points to I/O routing matrix

Forums Forums dLive Forums dLive feature suggestions Add FX Rack Units and Insert Points to I/O routing matrix

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of John McBae John McBae 2 months, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #95065
    Profile photo of John McBae
    John McBae
    Participant

    Reassigning large numbers of FX rack unit inputs and outputs (sorry I use aux’s and input channels for this since i need full processing here.) or assigning large numbers of insert paths (as you need to do when assigning Waves racks) is quite tedious with the current architecture. It can only be done from each channel/fx unit’s respective page, one by one. It would be much quicker if there were tabs for these in the I/O page’s routing matrix.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.