How to use Custom Layer QU16

Forums › Forums › GLD Forums › Archived GLD Discussions › How to use Custom Layer QU16

This topic contains 4 replies, has 3 voices, and was last updated by Profile photo of midbrain midbrain 10 years, 7 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • 2013/09/20 at 9:24 pm #24000
    Profile photo of midbrain
    midbrain
    Participant

    Hello,
    I have a question about my QU16. I loaded the new firmware V1.10 on my QU16. However, I experience trouble in the programming of the custom layer. I tried a lot of things, but nothing seems to work.
    Has anyone already done this? Can you please tell me how to program the custom layer?
    Thanks in advance for your help!

    Midbrain

    2013/09/20 at 10:15 pm #34880
    Profile photo of Rob-Spence
    Rob-Spence
    Participant

    Note that a new forum for QU-16 was created recentl.

    rob at lynxaudioservices dot com

    2013/09/21 at 8:27 am #34883
    Profile photo of midbrain
    midbrain
    Participant

    Dear Rob,

    Wear can I find it QU16 forum?
    Thanks for your answer.

    midbrain

    2013/09/21 at 4:12 pm #34886
    Profile photo of mamerica
    mamerica
    Participant

    I had this problem too. Don’t feel too bad.

    Press the Setup Button
    Select the Custom Layer Tab
    Touch the X under CH1
    Rotate The Encoder clockwise to select channel you want to control from that position.
    You can choose Inputs 1-16, ST1-ST3, FX1-FX4 Return, FX1-FX2 Send, Mix1-Mix10 and LR

    The Fn button below is used to add the next custom channel.

    mamerica
    Mpls, MN USA

    2013/09/23 at 1:13 pm #34908
    Profile photo of midbrain
    midbrain
    Participant

    Hello Mamerica,

    thanks for the explanation, it works perfectly [:)]
    many thanks

    Midbrain

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)

The forum ‘Archived GLD Discussions’ is closed to new topics and replies.