Topic: Suggestions for the next firmware update | Allen & Heath Digital Community

Suggestions for the next firmware update

This topic contains 7 replies, has 6 voices, and was last updated by Chris93 10 years, 6 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)

Author

Posts
2013/03/06 at 11:28 pm #23650

Dave
Participant

I would like to see a preview from the PEQ library before I apply it!

GLD-80, AR2412, Peavey Versarray 112s 218 & CS Amps eh

2013/03/06 at 11:36 pm #33360

papromike
Participant

Pull up the EQ preset without the “IN” button engaged

Vice President of Sales
Allen & Heath USA

2013/03/07 at 8:42 am #33364

Jono-Morgan
Participant

being able to run a compressor in one of the fx busses so you can run parallel would be awesome.
and the multiband compressor from ilive

2013/03/07 at 8:58 am #33365

Volum
Participant

+ 1 for the multiband compressor!

Also i BEG A&H to do something about the delaytimes in the FX engines. 1.36 seconds is just not long enough!

And what about beeing able to setup the musicians iPads to adjust their respective monitor-mixes? I had that on my Presonus, and it’s a FOH-tech’s dream!

Willy
FOH-tech.
GLD-80
AR2412
AR84

2013/03/07 at 11:52 am #33368

Chris93
Participant

You can return an FX unit to a channel(s) which gives you the same processing you have on any other input (gate, comp etc…).

What would be good if the hardware allows it would be an option to “decativate” un-needed processing channels as part of the config setup (probably in blocks of to allow that processing power to be traded for more mix outs, multiband compressors etc.

Would a longer max delay FX time be do-able? It would be a nice option even if it meant using up two Rack FX slots.

Chris

2013/03/08 at 9:15 am #33375

jmibk
Participant

My wishes for the new update:
> +1 for the multiband comp.
> more delay time tap delay
> sidechaining the compressor – select an aux bus to feed the compressors ‘source’.

2013/03/08 at 7:08 pm #33387

Dave
Participant

quote:

Originally posted by papromike

Pull up the EQ preset without the “IN” button engaged

Vice President of Sales
Allen & Heath USA

I tried this – deselect IN, pick EQ preset in library, recall. It loads the preset and selects IN all at once – no preview.

GLD-80, AR2412, Peavey Versarray 112s 218 & CS Amps eh

2013/03/09 at 3:57 am #33391

Chris93
Participant

Is the “IN” status saved as part of the library file?

What happens if you deselect “IN” and overwrite it, then recall it again?

Chris
Author

Posts