Post-Fade Aux

Forums › Forums › GLD Forums › Archived GLD Discussions › Post-Fade Aux

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of scottwc scottwc 11 years, 5 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2012/11/10 at 10:20 am #23400
    Profile photo of scottwc
    scottwc
    Participant

    Hey All,

    Is there a way to assign an aux send as being post fader. As far as I can tell there are only options to select the send point pre-fader but not one for post.

    I’m asking this to run aux-fed subs, yes I know there are ways to run it without using an aux, but it would be really nice to have a post-fade aux. Maybe I’m just missing an option somewhere?

    Cheers,
    Scott

    2012/11/10 at 2:24 pm #31998
    Profile photo of clarocque
    clarocque
    Participant

    Scott… check page 21 in manual:

    Hold down the Pre/Post key and press channel
    Sel keys to toggle each source pre or post fader.
    Current PRE status is displayed on the lower part
    of the channel strip LCDs.

    T112, iDR48 w/M-DANTE, PL10, MixPad, Editor
    GLD-80 w/M-DANTE, GLD-AR2412, GLD-AR84 (2)
    MacBook Pro, Mac Mini
    Lion/Logic Pro/PT10
    All latest versions/firmware

    2012/11/10 at 7:11 pm #32001
    Profile photo of Chris93
    Chris93
    Participant

    If it doesn’t say “PRE”, it’s post.

    Chris

    2012/11/11 at 12:36 am #32007
    Profile photo of scottwc
    scottwc
    Participant

    Thanks guys!

    I must have been looking in the wrong place.

    Cheers,
    Scott

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

The forum ‘Archived GLD Discussions’ is closed to new topics and replies.