Dual rack mode routing problem

Forums Forums iLive Forums Archived iLive Discussions Dual rack mode routing problem

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #23297
    Profile photo of josiaspiconejosiaspicone
    Participant

    Hello. I have a problem with dual rack mode. I can’t send the slave input chanels to the mixing buses including pafl. I think that is a ESB routing error… Any ideas? [B)]

    Solo se que no se nada

    #31393
    Profile photo of SteffenRSteffenR
    Participant

    wich systems do you use?

    SRV-AVB
    R-72, iDR-16, xDR-16, Dante

    #31307
    Profile photo of Mr-BMr-B
    Participant

    https://allen-heath.helpserve.com/Knowledgebase/Article/View/211/0/understanding-dual-rack-mode-in-ilive

    This might help, which version of the software are you running 1.83 should be pretty seamless.

    Where in Argentina are you based?

    Ian B.

    #31325
    Profile photo of Leon BigEars A&HLeon BigEars A&H
    Participant

    You mentioned ESB –
    If you are using Modular MixRacks with an EtherSound card in the top slot (port-A) of the RAB in the Slave Rack, then you need to pay attention to the ES card routing setup (maybe that ES card was used in port-B before?) Connect EtherSound Monitor program to the cards and check the signal flow for 64 channels in each direction.

    please do not adjust your set; normal service will be resumed as soon as possible!

Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Archived iLive Discussions’ is closed to new topics and replies.