Topic: Help needed with Speaker Matrix Processor | Allen & Heath Digital Community

Help needed with Speaker Matrix Processor

This topic contains 7 replies, has 4 voices, and was last updated by SteffenR 11 years, 11 months ago.

Viewing 8 posts - 1 through 8 (of 8 total)

Author

Posts
2012/05/15 at 6:21 pm #23151

Anonymous

I load LCR+XOSub from the Library.

I Fully Unassign the Sends and assign the following:

IP1 – Mains Out L
IP2 – Mains Out R
IP3 – Mains Out SUB

I don’t hear any changes when I turn the XOVR on. Do I need to set the Outputs? If so, how?

Thanks for any suggestions.

2012/05/16 at 6:11 am #30597

Albin
Participant

Did you assign the outputs as well (outputs on the mixrack?)

2012/05/16 at 7:13 am #30598

Anonymous

I assigned the outputs by loading the default show FOH-LRSub.

2012/05/16 at 7:50 am #30599

Albin
Participant

What i meant was – in the “output” tab of the editor or the page on the console – did you assign the speaker matrix outputs to your mixrack outputs?

Thats not done simply by loading the show.

2012/05/16 at 8:08 am #30600

Anonymous

Thanks for your help!

There is a tab called View Outputs in the SPKR Matrix panel. It reads as follows:

Output Targets
OP1: Not Assigned
OP2: Not Assigned
OP3: Not Assigned

and so on.

I use the Editor only and don’t see how to assign these outputs.

2012/05/16 at 9:26 am #30602

CareyD
Participant

Open the ‘Setup’ menu in Editor and select ‘I/O Patch’. Then click the socket you want to assign, open the drop down ‘output source’ menu, select ‘Rack FX’ near the bottom of the list, select the FX unit output from the speaker processor then hit ‘Apply’.
Hope that helps,
Carey

2012/05/16 at 4:58 pm #30605

Anonymous

Perfect! Thanks again!

2012/05/17 at 8:53 am #30613

SteffenR
Participant

quote:

Originally posted by Carey D

Open the ‘Setup’ menu in Editor and select ‘I/O Patch’. Then click the socket you want to assign, open the drop down ‘output source’ menu, select ‘Rack FX’ near the bottom of the list, select the FX unit output from the speaker processor then hit ‘Apply’.

And it helps to store this as a scene…

I mostly use scene numbers over 200 for configuring the surface and the complete system

SRV-AVB
R-72, iDR-16, xDR-16, Dante
Author

Posts