Dante

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of AndyH AndyH 9 years, 4 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #23039
    Profile photo of Giorgiomotore
    Giorgiomotore
    Participant

    Hi
    Got the following message in Dante contollers eventfile:
    timed out 3 times sending message querycapabilities to allen&heath 0600bf and 0602b8 giving up.
    Setup
    2 T112
    idr 48
    idr 32
    2 Dante
    Fv 18.2
    any ideas?
    grez
    Flavio

    #30182
    Profile photo of AndyH
    AndyH
    Moderator

    Hi Giorgiomotore,

    It sounds like Dante Controller is unable to ‘see’ the Dante module any more. The most likely reason would be if the cable between the card and your PC/Mac got disconnected.

    The easiest way to see if a cable has become loose or disconnected, is to check out the LEDs on the front of the Dante module.

    If your cables appear fine, you might also want to check your IP address settings. Dante Controller needs to be on a compatible IP address to communicate to the Dante module. As default; you will need to set your network address to DHCP enabled. With no static IP address.

    I’m not really sure what else could stop Dante Controller from communicating with the module.

    If the above ideas don’t work, perhaps it’s worth giving A&H Support an e-mail as they may be able to help further (http://www.allen-heath.com/uk/support/Pages/support.aspx)

    Hope that’s of some help,

    AndyH

Viewing 2 posts - 1 through 2 (of 2 total)

The forum ‘Archived iLive Discussions’ is closed to new topics and replies.