Dante on surface port B

Forums › Forums › iLive Forums › Archived iLive Discussions › Dante on surface port B

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of Stealth Stealth 12 years, 2 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2012/01/24 at 11:08 am #23035
    Profile photo of Rexeltw
    Rexeltw
    Participant

    Hello all

    Just wondering if anyone knew whether it is possible to use a Dante card on Port B on a RAB2 on a modular surface. Just trying to work out if I can keep Ethersound on port A & B of the mix rack but record onto Dante at FOH. Any answers welcome! [:D]

    .

    Just remember kids no matter how good your mixing is you can’t polish a turd…

    2012/01/24 at 3:08 pm #30178
    Profile photo of Stealth
    Stealth
    Moderator

    Hi Rexeltw

    Currently it is not possible to put a Dante module in Port B of the Surface. The only module that you can fit to Port B of the surface is an MMO module, which uses the remaining 30 channels not used up by the Port A surface Link.

    Regards
    Sam A&H

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

The forum ‘Archived iLive Discussions’ is closed to new topics and replies.