ground loop/GL2

Forums › Forums › iLive Forums › Archived iLive Discussions › ground loop/GL2

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of ddff_lv ddff_lv 13 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2011/03/25 at 2:35 pm #22700
    Profile photo of apoor
    apoor
    Participant

    Hello,

    I have 2 GL2 mixers that connect (slave/master) via a computer ribbon. I intalled them in my church last weekend and found I have a buzz when the ribbon is attached. No buzz exists if the mixers are used alone. I have tried the ground lift switches in various combination on each of the the mixers to no avail. Do I have a problem with the ribbon? Any suggestions?

    Thanks,

    2011/03/25 at 8:38 pm #27785
    Profile photo of Mr-B
    Mr-B
    Participant

    Could I suggest you contact A&H technical, they are nice guys and very helpful. Just drop them an e-mail

    2011/03/25 at 9:39 pm #27786
    Profile photo of SteffenR
    SteffenR
    Participant

    What you mean with ribbon?

    SRV-AVB
    R-72, iDR-16, xDR-16

    2011/03/29 at 10:52 am #27812
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Does the ribbon cable you’re using meet requirements for console interconnection? Have you also tried original A&H cable?

    ddff

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

The forum ‘Archived iLive Discussions’ is closed to new topics and replies.