Topic: Change aux sends to pre-fade | Allen & Heath Digital Community

Change aux sends to pre-fade

This topic contains 5 replies, has 4 voices, and was last updated by CareyD 11 years, 8 months ago.

Viewing 6 posts - 1 through 6 (of 6 total)

Author

Posts
2010/11/18 at 4:44 pm #22545

Piehead
Participant

Hello everyone,

Is it possible to change all of the channels that send to a chosen Aux. to pre-fade? They are always set to post-fade which can be a pain sometimes (unless there is an easy way to change them all). I have just changed from LCR plus to LCR sub and it has reset everything to post-fade. Again, a bit of a pain.

Thanks

Simon

T112 + iDR48

2010/11/18 at 6:48 pm #26794

mumu
Participant

in editor,right click on the mix button (control/click on mac) on a aux channel-there you see routing….

cheers
dave

allen&heath iLive-144 /idr 64 / idr 48 (i am convinced there is a yamaha conspiracy against the release of the dante )

2010/11/19 at 1:03 pm #26800

Piehead
Participant

Brilliant! Now why didn’t I think of that ?! [:p]

I guess you can’t do similar from the surface?

Cheers

Piehead

T112 + iDR48

2010/11/19 at 1:15 pm #26801

mumu
Participant

dunno must be somewhere

cheers
dave

allen&heath iLive-144 /idr 64 / idr 48 (i am convinced there is a yamaha conspiracy against the release of the dante )

2010/11/19 at 1:37 pm #26802

Tonmike
Participant

AUX PRE / POST (Global)on surface

– Press the desired AUX MIX-Master
– Press and hold! PRE / POST (between fader banks)
– Press the AUX-Masters SEL at the same time

2012/08/19 at 10:32 am #31169

CareyD
Participant

Just something else to add:

Changing the bus configuration resets all DSP mix parameters. Before you do this save your current settings to a Scene using ‘Store All’. After changing the config simply Recall the Scene and your mix settings including Pre/Post settings will be restored.

Hope that helps
Carey
Author

Posts