I’m using T80 and idr32.

On saturday I had a show where for ease I changed one of my dca channels which is normally on the top layer and running aux mute to a group channel which was runnning a delay pair. As the auxes are also on dca one which is mute all didn’t think much of it until I unmuted DCA one and the auxes were still muted. I then had to go to another layer and change an unused group channel to the dca for the auxes unmute them and all was fine.

I was just wondering if there is any way that when you change a channel from one layer to another, in this case it was a dca on the top layer to a group which is on layer 4 that the channel you “swap” with becomes the original channel automatically. Ie I would expect the group on layer 4 to become the dca form layer one in this case, not the dca to disappear from the layers completely

http://www.maltingsaudio.co.uk