Reply To: Using QU-16 as crossover between tops and subs

Forums › Forums › Qu Forums › Qu general discussions › Using QU-16 as crossover between tops and subs › Reply To: Using QU-16 as crossover between tops and subs

2013/10/21 at 6:02 pm #35416
Profile photo of GCumbee
GCumbee
Participant

Just checked it on my GLD. That will work. Set the PEQ for low pass or hi cut filter. Right side bottom icon. Then use right knob on PEQ on board to sweep back to where you want. I am assuming here that the QU has the same ability to do this…