Reply To: Surface inputs over Dante

Forums Forums iLive Forums iLive general discussions Surface inputs over Dante Reply To: Surface inputs over Dante

#39992
Profile photo of ddff_lv
ddff_lv
Participant

Well there are 3 places where you do the patching- first of all via outputs section on console/editors you chose dante channels and put some signal in- bus output, channel direct out, mixrack input, etc. Then via Dante controller you route all transmitter channels to receiver (virtual sound card of your computer). Finally into your DAW you tell which virtual dante channels will go to appropriate recording tracks. If everything is done properly no problems should occur.
Regarding the mixrack input (which does not allow to chose surface as source) and input- direct out, basically they’re the same, but second can have different points where the signal is taken from- after the preamp, hpf, should it follow channel fader and/or mute and, of course, source can be surface inputs.

ddff