Forums › Forums › Qu Forums › Qu general discussions › Qu design flaws › Reply To: Qu design flaws
2014/01/26 at 5:31 pm
#37426
mamericaParticipant
You can adjust the brightness of the LED’s by holding down Setup * Button and turning the encoder. I had just the opposite problem when I first played around with mine. I had to turn them down.
The new Qu-24 has additional LED’s above the faders.
I think the trick to working with layers (and it is mentioned in the manual) is to always return to the main layer after adjusting something else.
Lastly, if you can use the custom layer, you can mix and match inputs and outputs from the different layers so you don’t have to switch very often.
